[GBC] Trimming the shell
Shells from Hispeedido can be used with laminated display kits without modifications. Other shells require extensive modifications, and you should have the appropriate experience to carry them out.
Modifications
Section titled “Modifications”The screen window has to be enlarged so the LCD can be inserted into the shell.

Place the LCD into the shell back-side forward and mark the position of the adhesive tape with a water-soluble pen.

Now connect the marks to set the cutting line. To make it easier to see while cutting, you can also apply some tape.

After cutting through both sides, cut through the top edge so the frame can already be bent a little.

If you now score the bottom edge deeply enough, the frame will break out cleanly with a bit of bending.


On the inside, the rib on the bottom of the display opening now has to be removed along its entire length.



The LCD can now be inserted into the shell from the front. Don’t forget to peel the backing off the adhesive strips first.

Caution: do not put any pressure on the display! The LCD should sit firmly, but go in without force.
