Skip to content

[GBC] FunnyPlaying LiPo Battery Mod

Make sure your kit includes all parts:

First, solder the battery control module (BCM) on top of the regulator. It’s tacked down at three points that connect to the pins of the regulator.

Charging module on the regulator

Once the three points of the BCM are soldered, remove fuse F1 from the board. We recommend leaving one leg of the fuse soldered, so you can put it back if you ever want to undo the mod.

Fuse F1

Next, tin the wires and solder them to the IN and OUT pads on the BCM. Their other ends go to the pads the fuse was removed from: IN to the right pad, OUT to the left.

Wires from IN and OUT to the fuse pads

That’s all the electronics for this mod. Depending on your shell, you may have to trim the battery compartment so the battery fits. We used flush cutters to remove the bulk of the plastic and then smoothed it out with a rotary tool.

Battery compartment before trimming

Battery compartment after trimming

Once there’s room for the battery, run its wire through the hole in the battery compartment and plug it into the BCM: place the connector over the socket and press down gently.

Plugging the battery into the charging module

Now you can put your console back together as normal.

Battery installed