Skip to content

[GBC] RetroSix CleanJuice

The Game Boy Color CleanJuice charges via USB-C.

Game Boy Color USB-C board

USB-C pad on the CleanJuice Air

First, remove the DC charging port from the Game Boy Color. The simplest way is to apply plenty of solder to the pads on the underside and use tweezers to gently bend the port away from the board while heating the pads with your soldering iron.

Alternatively, use a hot air station.

DC jack on the Game Boy Color

Game Boy Color with the DC jack removed

Now solder the USB-C power board in place, aligning its two holes with pins 3 and 2 of the original port.

USB-C charging port soldered into the Game Boy Color

Use 28AWG / 0.2 mm enamel or Kynar wire, or thicker. Solder a single wire to the remaining pad of the USB-C board.

Enamel wire on the USB-C board

Pass it through the battery positive hole and solder it to the USB-C pad on the CleanJuice.

USB-C wire soldered to the CleanJuice Air

RetroSix shells will soon come with a pre-moulded USB-C opening.

Until then, you need to drill out a hole. The USB-C port sits perfectly centered over the original DC hole, so drill two 3.5 mm holes to the left and right of the DC hole, and finally drill the center hole out to 3.5 mm.

USB-C opening in the Game Boy Color shell

If needed, you can make it slightly larger with a more common 4 mm drill bit.

Plug any USB-C charger into the port and the CleanJuice starts charging. There are 2 LEDs on the CleanJuice PCB:

  • Green lights up as soon as USB-C is providing power. You can then run your console from USB without draining the battery. If it does not light up, check your soldering on the USB-C port as well as your USB-C cable and charger.
  • Orange lights up while the battery is charging and goes off once charging is complete. A completely flat battery takes up to 3 hours.

So while charging you will see green and orange; once the battery is full, only green stays on.

Charging LEDs with USB-C connected

Since the GBC uses the same battery as the Game Boy Advance, you can expect the same battery life as described for the GBA.

That depends on your console and the upgrades you have. It’s all about the watts: standard 2x AA batteries with 1200 mAh have 2.88 watts, the best AAs on the market (2x Eneloop Pro) have 6 watts, and the CleanJuice has 6.29 watts. More power = longer life. Estimates for different setups are listed on the GBA page.

Do I need to solder or cut anything for the CleanJuice?

Section titled “Do I need to solder or cut anything for the CleanJuice?”

CleanJuice packs are designed as tool-free drop-in mods without soldering. On the Game Boy Color, USB-C charging is the exception: you solder the USB-C board in place of the DC jack, connect it to the CleanJuice with a single wire and drill out the opening in the shell (see Installation with USB-C).