[GBP] Shell Disassembly
- Tri-wing screwdriver (for the shell screws)
- Phillips screwdriver (for the board screws)
Disassembly
Section titled “Disassembly”- Remove the tri-wing screws on the back of the shell. The back cover then pulls off.
- Undo the Phillips screws holding the circuit board.
- Pull the tabs on either side of the LCD ribbon connector (at the top of the console) upwards, towards the top of the shell. This releases the ribbon. Then gently pull it out.
- Now you can remove the main board.
- If you are replacing the screen, take the old LCD out of the front shell. Set aside all buttons, rubber pads and screws.
Screw overview
Section titled “Screw overview”So every screw ends up in the right place when you reassemble:



