Skip to content

[GBC] AMOLED XL Touch Kit by Hispeedido

With the GBC AMOLED XL Touch Kit from Hispeedido, the glass lens is already bonded industrially during production, which makes installation quick and easy. For the installation, you need to solder a wire between the PCB and the power switch of the GBC.

  • Always do a function test , BEFORE you install the IPS kit! Kits that have already been installed cannot be returned under warranty. You can see how to test the kit externally here: How do I test the LCD
  • The LCD is very fragile and sensitive to pressure, impacts, etc. Please be especially careful when handling the LCD during installation

The kit includes the following components

To open the shell you need

You can find suitable tool kits here

For an LCD mod, the 100uF capacitor should be replaced with a 680uF capacitor to reduce noise.

The pins of the cartridge port can put pressure on the LCD, which can cause permanent damage. That’s why the pins have to be trimmed as short as possible with flush cutters. Watch out for flying pieces and protect your eyes!

With the compatible shells from Hispeedido you simply drop the LCD in (drop-in). It is possible to use the kit with other shells, but that requires extensive modifications. You can find the shell trim guide here: [GBC] Trimming the shell. Note: RetroSix shells are usually not suitable.

Solder the included wire to the “BAT” contact on the PCB

Connect the PCB to the LCD - to do this, place the PCB on the back of the LCD and then route the connecting cable through the opening provided for the connector. After that, secure the board with the included adhesive strips so it can’t slip.

Remove the adhesive strips.

Insert the LCD into the shell, starting from the bottom.

Make sure the wire you soldered earlier doesn’t end up behind the cover on the shell.

Connect the ribbon cable to the PCB.

Now solder the wire to contact “C” on the power switch of the Game Boy Color mainboard, then connect the ribbon cable to the LCD connector.

Screw the shell back together and enjoy your new screen! :)

The AMOLED kit is controlled via a menu that you operate using the touchscreen.

  • Touch the lower third of the screen for 5 seconds to open the menu
  • Swipe up or down over the open menu to change pages
  • Change options by touching the arrow buttons
  • Close the menu by touching the screen outside the menu for 3 seconds